ENGLISH

jumbo roll film shipments
2017-05-18 09:44:12

jumbo roll film shipments

There are usually three methods of container packing: that is, all of them are manned and loaded with a forklift truck (forklift) into the box, and then manned and all loaded with machinery, such as a pallet ) Fork forklift truck in the box stacking.

 

1, in any case when the goods loaded, the weight of the goods loaded in the box can not exceed the maximum load capacity of the container, that is, the total container minus the container's own weight. Under normal circumstances, the total weight and weight will be marked on the container door.

 

2, the density of each container unit is a certain, so the same kind of goods in the box, as long as the density of goods, you can determine whether the heavy or light goods. Cheng Qiwei said that if the density of goods is greater than the unit weight of the box is heavy goods, and vice versa for the light goods. Timely and clearly distinguish between these two different situations, to improve the efficiency of packing is very important.

 

3, the load to make the load on the bottom of the balance, in particular, to strictly prohibit the load center of gravity at the end of the situation.

 

4, to avoid generating a concentrated load. "If the loading of machinery and equipment and other heavy cargo, the bottom of the box should be covered with wood and other cushioning materials, as far as possible to disperse the load.The average container bottom surface area of ​​the average security load is roughly: 20 feet container 1330x9.8N / m, 40 feet The container is 980x9.8N / m2.

 

5, the use of human loading should pay attention to whether the packaging "can not be inverted", "flat", "vertical release" and other loading and unloading signs. Be sure to use the loading tool correctly and do not use the hand hook. The goods contained in the box are loaded neatly and packed well. Easy to bundle and package fragile goods, to use the liner or insert the plywood between the goods to prevent the goods in the box to move.

 

6, loading cargo board cargo, we must accurately grasp the internal dimensions of the container and the external dimensions of the packaging in order to calculate the number of loads in order to achieve the purpose of minimizing the abandonment of the goods.

 

7, with a forklift truck packing, will be the height of the mechanical lifting height and mast height restrictions. Therefore, the conditions permit, forklift box can be loaded two layers, but up and down to leave a certain gap. If the conditions are not allowed to load two layers at a time, in the case of the second floor, taking into account the free lifting height of the forklift and the height of the forklift gantry may rise, A layer of goods minus the height of freedom to enhance the height, so the second layer of goods can be installed in the third layer of goods on the top.

 

In addition, the general use of ordinary lifting capacity of 2 tons of forklift, the free lifting height of 1250px or so. But there is a full freedom to raise the height of the forklift, this machine as long as the height of the box allowed, it is not affected by the height of the mast lift, and can easily stack two layers of goods. In addition, it should also be noted that the following goods should be covered with mats, so that the fork can be successfully pulled out.

 

Finally, the goods are best not to nude, at least to have a packaging, do not blindly to save space and cause damage to the goods. The general goods will be packaged, only such as large machines such as boilers, building materials and the like will be more trouble, must be bundled, tied to prevent loosening. In fact, as long as careful, there will not be too much of a problem.